OneUp V2 Dropper Lever med 22.2mm Klemme
  • OneUp V2 Dropper Lever med 22.2mm Klemme
  • Oneup Dropper Lever 22.2mm Klemme 1_Web

OneUp V2 Dropper Lever med 22.2mm Klemme

OneUp

Varenr.
1C0577
Lager:
På lager
Pris:
kr 383 Eks. MVA
Før:
kr 479

Bestilte varer sendes med Posten eller PostNord
Gratis frakt på ordre over 1500,- 
Standard frakt er 99,-
Hjemlevering 299,-
Sendinger til Svalbard 299,-
*Sykler 750,-
Elsykler 1500,-
Alle Trek sykler må hentes i butikk

Pakken blir som regel postlagt innen 24t etter at vi har mottatt din bestilling - så sant vi har varene på lager. Pakken vil være fremme hos mottakeren innen 2-5 virkedager, avhengig av hvor i landet du bor.

Vi tilbyr gratis montering ved kjøp av ski & binding. Husk å oppgi sålelengde (mm) & vekt (kg).

Med Klarna kan du delbetale mellom 3 og 36 måneder.

Kvantumsrabatt

Loading...
A better remote for any cable operated dropper

An Aluminum remote with an oversized bearing and a super smooth action. The unique lever position allows you to keep a stronger grip on the bars while actuating your post. Don't think twice about dropping your post, even when charging into technical sections. The OneUp lever mimics your R/H shifter’s inboard upshift paddle position instead of the usual downshift paddle position of most remotes. This position requires considerably less thumb movement to reach the lever.

NO BLEEDING

The cable setup is quick and easy. The cable clamps at the lever making shortening the housing length for clean routing a breeze. Unlike a hydraulically actuated dropper, there is no temperature sensitivity and If your remote gets damaged you can still lower or extend your post by removing it from your frame and pushing on the actuator by hand.

Kit includes cable and housing

Compatible with all cable actuated dropper posts.

Weight: Remote with 22.2mm Bar Clamp - 46g

INSTALL INSTRUCTIONS

  • Loosely attach the hinged clamp to your handlebar (Left side of brake for SRAM, Right side of brake for Shimano)
  • Attach the remote body to the clamp using your preferred mounting hole.
  • Torque the remote body to the clamp using a 4mm hex to 3Nm
  • Loosen the 22.2mm clamp and rotate the OneUp dropper remote until the remote body is parallel to the brake lever
  • Snug the 22.2mm clamp to 1Nm max.
    Din nettleser er utdatert!

    For å kunne bruke alle funksjoner på nettsiden må du oppdatere nettleseren. Oppdater min nettleser nå

    ×